Hey Group,

I have a question.

I just replace my handlebars and in doing so had to remove and replace my gas tank and throttle cable.

After putting everything back, I have gasoline pouring out of the overflow tube of my carburator. It won't stop. I've tried running the engine and when I give it throttle naturally the gas stops flowing but even in idle its just flowing out of the tube.

Is my float stuck and if so is there an easy remedy to fixing it.

I don't want to ride my Bike until I can stop this gas from coming out.

Devin  

You need to atek the carb off and appart. View inside. Clear debree in the float needle seat area. Then install a fuel filter. This will aleiviate that problem. If it dosen't have debree then you need to look at the float needle. If there is a worn ring around it replace the pair as a set.